Keeping the child seat just touching the vehicle seat gives the best protection in a severe crash. Use the following procedure to reset the fuel pump shut-off switch. Make a further check for leaks in the fuel system. See your Ford or Lincoln Mercury dealer. To access this information, special equipment must be directly connected to the recording modules. Ford Motor Company and Ford of Canada do not access event data recorder information without obtaining consent,.
Carefully install the tail lamp assembly on the body side panel and secure it with two bolts. Pull lever up to adjust seatback. Just recently, the wrench light along with the engine light came on together. Push down on the child seat while pulling on the loose end of the lap belt webbing to tighten the belt. Ford recommends the use of a digital or dial type tire pressure gauge rather than a stick type tire pressure gauge. If the engine still fails to start, repeat Step 1. The engine may misfire or run poorly.
Use of any tire or wheel not recommended by Ford can affect the safety and performance of your vehicle, which could result in an increased risk of loss of vehicle control, vehicle rollover, personal injury and death. If you must use a forward-facing child seat in the front seat, move the seat all the way back. It appears the problem has been solved. When you remove the cover you will find a connector which resembles a tire valve stem. Inflate all tires to the inflation pressure recommended by Ford Motor Company. While the belt retracts, guide the tongue to its original position to prevent it from striking you or the vehicle. Ensure the vehicle is electronically unlocked.
This filter helps protect against engine wear by screening out abrasives, such as carbon, sand, dust and bits of metal before they can get into your oil. Here read this Your problem could be cause by lose ground connection ,a lose network connection. Get access to our 2006 Ford Taurus repair information right now, online. NewUsedFilter selectedNewUsedList, null ; newUsedFilter. TransmissionFilter selectedTransmissionList, transmissionTemplate ; } listingsSearchManager.
Copyright © 2005 Ford Motor Company. The lap belt should rest low and snug across the hips, never up high across the stomach. The four-speed-automatic transmission incorporates adaptive shift control. Make sure that the mat does not interfere with the operation of the accelerator or the brake pedal. Handling isn't particularly nimble, the turning circle is wide, braking is unimpressive and while noise levels are tolerable, it was louder than some competing models. Ask your fuel supplier about gasolines that meet the World-wide Fuel Charter.
See Engine oil in the Maintenance and Specifications chapter for more information on oil usage. Remove the upper trim panel. Press the control to move the seat forward, backward, up or down. Allow the safety belt to retract to remove any slack in the belt. For forward-facing child seats, the tether strap must also be attached to the proper tether anchor. Check engine light is consistently lit. Install bulb socket in lamp assembly by turning clockwise.
To find the problem one should take there vehicle to a qualified repair shop. After airbag deployment, it is normal to notice a smoke-like, powdery residue or smell the burnt propellant. Turn the headlamps on and make sure they work properly. Safety belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted. These products are available from your dealer. The company sells a large range of vehicles, including commercial and luxury cars. Connect the other end of the positive + cable to the positive + terminal of the assisting battery.
The engine must warm up to its normal operating temperature. Insert the belt tongue into the proper buckle the buckle closest to the direction the tongue is coming from for that seating position until. Use only Ford recommended replacement fasteners. If your vehicle will be towing a trailer, load from your trailer will be transferred to your vehicle. Your vehicle may not have enough braking power and your chances of having a collision greatly increase.
Visually inspect the tires to make sure there are no nails or other objects embedded that could poke a hole in the tire and cause an air leak. Never remove the coolant reservoir cap while the engine is running or hot. Adaptive Shift Strategy offers the optimal transmission operation and shift quality. Engine oil filler cap 6. Inflate all tires to the inflation pressure recommended by Ford Motor Company. Note: All doors must be closed and remain closed throughout the process. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap.