The markings have the following meanings: The raised feature must always be oriented toward the center of the cylinder head. A rear seat is a safer place to secure a forward-facing child restraint. The was later expanded to 3. Hand start all the camshaft bearing cap bolts. Install the intake manifold cover.
If the belt is not long enough, see Safety Belt Extender on page 1-32. You get more time to stop. As each new track starts to play, the track number will appear on the display. Tighten the bolt to 74 ft. Slide the drive belt off of the belt idler pulley. It also tells you some things you should not do with safety belts.
This dust could cause breathing problems for people with a history of asthma or other breathing trouble. Mark the bearing caps to ensure they are installed in the original position. Install the engine mount strut. Install and tighten the camshaft position actuators. This helps to reduce the time it takes for the vehicle to cool down. Inspect the camshaft position actuator locating notch 3 for damage or wear. Remove the radiator outlet hose from the thermostat housing.
Install the engine front cover. Install the rocker arms and tighten to 24 ft. Lower the vehicle and support the transaxle. Disconnect the engine wiring harness electrical connector from the fuel injector wiring harness electrical connector. Install the engine mount lower nuts and tighten to 32 ft. Install the engine to the vehicle.
Using the tool, rotate the tensioner counterclockwise in order to release the tensioner from the drive belt. Follow these steps to program up to three channels: 1. Remove the radiator surge tank inlet hose from the inlet pipe. Install the upper and lower intake manifolds. It is for this reason that Pontiac owners will benefit from having a service manual in their car in anticipation of the times when things do go wrong. Remove the lower intake manifold gaskets and seals.
Install the torque converter covers. If a child restraint has been installed and the on indicator is lit, turn the vehicle off. Poor fuel quality will cause your engine not to run as efficiently as designed. Position the transaxle to oil pan brace, install and tighten the bolts to 37 ft. Remove and discard the exhaust manifold gasket. This pigtail should not be removed from the sensor. Clean the lower intake manifold gasket and seal surfaces on the cylinder heads and the engine block.
Women generally have a lower relative percentage of body water than men. If you run the engine, it could lose all coolant. Here is why: They work. There are good medical, psychological, and developmental reasons for these laws. Install the exhaust manifold nuts and tighten to 12 ft. Remove the convenience net, if the vehicle has one.
Start the engine again and repeat this only when you feel really uncomfortable from the cold. This system is designed to make installation of a child restraint easier. Apply a liberal amount of lubricant to the camshaft journals and the left cylinder head camshaft carriers. Chilton Total Service series and System-Specific Repair manuals focus on specialized areas of auto repair providing more detail and theory. Position and install the exhaust manifold with gasket to the cylinder head. Install the upper transaxle-to-engine bolts and the stud.